Alabama Szer Kft.
01
Size
Let us clarify the length, edges, bending angles, number and the fact that the element is installed on a facade, roof or hall.
Tin edge bending for 6000 mm length hall plates.
We make long, straight and clean tin batteries for halls, facades and connections around the roof. The 6000 mm bending length is an advantage where less folding, better running and more orderly appearance is required.
Sheet metal edge bending
Long nails, covers and decorative plates, where appearance counts.
For 6000 mm length, we undertake tin-lined liverage for industrial halls, settlement buildings, facade covers, roofing and waterfront closures. The long bending gives less folding, more straight running and a more organized appearance to the hall records.
Drawing, pattern or on-site rediscussion, for wall riveting, facade covers, decorative plates, ledge profile, roof-type locking element and cover accessories. The aim is to ensure that the finished tin element fits precisely, also works in drainage and provides a clear line in the visible buildings.
In industrial buildings and industrial hall construction of tin plates is often the final, mindful detail. Therefore, the size, bending profile, material selection and assembly sequence count together to ensure that cover, closure and connection remain orderly over the long term.
- Concrete bending 6000 mm long
- Ties and facades
- water-nosed, roofing and sealing elements
- ornamental plates and covers
The big length, straight running, and clean edges are the key to the tin bending. These plates give you visible locks and covers at the chests and facades.
Session
The main steps of tinker bending.
02
6000 mm bending
The long disk will receive the desired profile. The aim of the straight edge is to run nice and make the plate on the site exactly fit up.
03
Profile and control
We check the profile, the edges and the length of the finished elements. In repeated elements, it is important that each piece is made with the same logic.
04
Installation
Disks can be replaced as hall corners, blankets, waternose elements or facade accessories, adapted to the full execution sequence.
Would you like to make a deal for Tin Bending?
Write down the necessary length, number, profile, material and that it is a hall breaker, facade cover, waterfront element or other tin plate.
Automatically translated from Hungarian. Read the original